پانی کا پمپ کیا ہے

پانی کے پمپوں کے مختلف استعمال ہیں، مختلف ترسیل مائع میڈیا، مختلف بہاؤ کی شرح، اور مختلف لفٹ رینج ہیں. لہذا، یقینا، ان کی ساختی شکلیں اور مواد بھی مختلف ہیں. خلاصہ کے طور پر ، انہیں تقریبا تقسیم کیا جاسکتا ہے: 1. شہری پانی کی فراہمی 2 ، سیوریج سسٹم 3 ، سول انجینئرنگ ، بلڈنگ سسٹم 4 ، زرعی پانی کی بچت کا نظام 5 ، پاور اسٹیشن سسٹم ، 6 ، کیمیکل سسٹم 7 ، پٹرولیم انڈسٹری سسٹم 8 ، کان کنی اور دھات کاری کا نظام 9 ، لائٹ انڈسٹری سسٹم 10 ، جہاز کا نظام۔

1. If the پانی کا پمپ has any small fault, remember not to let it work. If the packing of the پانی کا پمپ shaft is worn out, it should be added in time. If the پانی کا پمپ is continued to be used, air will leak.

2. If the پانی کا پمپ vibrates strongly during use, be sure to stop and check the cause, otherwise it will also cause damage to the pump.

3. The پانی کا پمپ must be maintained after use. For example, when the پانی کا پمپ is used up, the water in the پانی کا پمپ should be cleaned up. It is best to remove the water pipe and rinse it with clean water.

4. The tape on the پانی کا پمپ should also be removed, then rinsed with water and dried in the light. Do not put the tape in a dark and humid place. The tape of the پانی کا پمپ must not be stained with oil, let alone some sticky things on the tape.

Energy conservation and emission reduction have become the main content of China's economic development plan, especially for power, steel, non-ferrous metals, petrochemicals, پانی کا علاج and other industries with high energy consumption, more stringent emission reduction policies have been put forward. As the fluid conveying equipment in the industrial center, the پانی کا پمپ occupies the main part of energy consumption, and it has become the main problem to be solved in the energy saving operation.

The most common way to drive the پانی کا پمپ is to drive it with an electric motor. The energy saving method of the pump is mainly to make the pump unit (pump, prime mover and conversion part) run at the highest power, so that the electric energy consumed by the external input is reduced to the lowest point. The energy saving of the pump is a comprehensive technology, which involves the energy saving of the pump itself, the energy saving of the system and the operation of the application management.